PLANET XGS3-24042 - Manual (Page 881)

45-26
45.3.20 ipv6 pim ignore-rp-set-priority
Command:
ipv6 pim ignore-rp-set-priority
no ipv6 pim ignore-rp-set-priority
Function:
When RP selection is carried out, this command configures the switch to enable Hashing regulation
and ignore RP priority. This command is used to interact with older Cisco IOS versions.
Command Mode:
Global Mode
Usage Guide:
When selecting RP, PIM usually will select according to RP priority. When this command is
configured, PIM will not select according to RP priority. Unless there are older routers in the net, this
command is not recommended.
Example:
Configure to ignore RP priority.
Switch(config)#ipv6 pim ignore-rp-set-priority
45.3.21 ipv6 pim jp-timer
Command:
ipv6 pim jp-timer <value>
no ipv6 pim jp-timer
Function:
Configure to add JP timer. no ipv6 pim jp-timer restores the default value.
Parameter:
<value> ranges from 10 to 65535
Default:
60s
Command Mode:
Global Mode
Usage Guide:
Configure the interval of transmitting J/P messages to59s.
Example:
Switch(config)#ipv6 pim jp-timer 59