PLANET XGS3-24042 - Manual (Page 812)

44-87
match configured access-list, such as matching: permit, the interface can be added, otherwise do
not be added.
Example:
Switch(config)#intere
Switch(Config-If-Ethernet)#ip multicast destination-control access-group 6000
Switch (Config-If-Ethernet )#
44.8.4 ip multicast destination-control access-group
(sip)
Command:
ip multicast destination-control <IPADDRESS/M> access-group <6000-7999>
no ip multicast destination-control <IPADDRESS/M> access-group <6000-7999>
Function:
Configure multicast destination-control access-list used on specified net segment, the “no ip
multicast destination-control <IPADDRESS/M> access-group <6000-7999>” command deletes
this configuration.
Parameter:
<IPADDRESS/M>: IP address and mask length;
<6000-7999>: Destination control access-list number.
Command Mode:
Global Mode
Usage Guide:
The command is only working under global multicast destination-control enabled, after configuring
the command, if IGMP-SPOOPING or IGMP is enabled, for adding the members to multicast group.
If configuring multicast destination-control on specified net segment of transmitted igmp-report, and
match configured access-list, such as matching permit, the interface can be added, otherwise do
not be added. If relevant group or source in show ip igmp groups detail has been established before
executing the command, it needs to execute clear ip igmp groups command to clear relevant groups
in Admin mode.
Example:
Switch(config)#ip multicast destination-control 10.1.1.0/24 access-group 6000