PLANET XGS3-24042 - Manual (Page 666)

37-305
37.69 neighbor route-reflector-client
Command:
neighbor {<ip-address>|<TAG>} route-reflector-client
no neighbor {<ip-address>|<TAG>} route-reflector-client
Function:
Configure the route reflector client. The “no neighbor {<ip-address>|<TAG>}
route-reflector-client” command cancels this configuration
Parameter:
<ip-address>: Neighbor IP address
<TAG>: Name of peer group
Default:
Not configured.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
The route reflection is used for reducing the peers when the internal IBGP routers inside AS are too
much. The client only exchanges messages with route reflector while the reflector deals with
message exchange among each client and other IBGP, EBGP routers. This command configures
itself as the route reflector, while specific peer group is as its client. Note: this configuration is only
available inside AS.
Example:
Switch(config)#router bgp 100
Switch(config-router)#neighbor 10.1.1.66 remote 100
Switch(config-router)#neighbor 10.1.1.66 route-reflector-client
Switch(config-router)#neighbor 10.1.1.68 remote 100
Switch(config-router)#neighbor 10.1.1.68 route-reflector-client
Switch(config-router)#
Related Command:
bgp client-to-client reflection, no bgp client-to-client reflection, bgp cluster-id
37.70 neighbor route-server-client
Command:
neighbor {<ip-address>|<TAG>} route-server-client
no neighbor {<ip-address>|<TAG>} route-server-client