PLANET XGS3-24042 - Manual (Page 238)

12-84
no voice-vlan {mac <mac-address> mask <mac-mask>|name <voice-name> |all}
Function:
Specify certain voice equipment to join in Voice VLAN; the "no" form of this command will let the
equipment leave the Voice VLAN.
Parameter:
Mac-address is the voice equipment MAC address, shown in ”xx-xx-xx-xx-xx-xx” format; mac-mask
is the last eight digit of the mask code of the MAC address, the valid values are: 0xff, 0xfe, 0xfc, 0xf8,
0xf0, 0xe0, 0xc0,0x80, 0x0; priority-id is the priority of the voice traffic, the valid range is 0–7; the
voice-name is the name of the voice equipment, which is to facilitate the equipment management;
all indicates all the MAC addresses of the voice equipments.
Command Mode:
Global Mode.
Default:
This command will add a specified voice equipment into the Voice VLAN, if a non VLAN labeled
data packet from the specified voice equipment enters through the switch port, then no matter
through which port the packet enters, it will belongs to Voice VLAN. The command will not interfere
with the packets of VLAN labels.
Example:
Add the 256 sets of voice equipments of the R&D department with MAC address ranging from
00-30-4f-11-22-00 to 00-30-4f-11-22-ff to the Voice VLAN.
Switch#config
Switch(config)#voice-vlan vlan 100
Switch(config)#voice-vlan mac 00-30-4f-11-22-00 mask 0 priority 5 name test
12.3.4 voice-vlan vlan
Command:
voice-vlan vlan <vlan-id>
no voice-vlan
Function:
Configure the specified VLAN to Voice VLAN; the “no voice-vlan” command cancels the Voice
VLAN configuration of this VLAN.
Parameter:
Vlan id is the number of the specified VLAN.
Command Mode:
Global Mode.
Default: