PLANET XGS3-24042 - Manual (Page 802)

44-77
Admin Mode
Usage Guide:
Enable this switch, and display DVMRP protocol executed relevant messages.
44.7.2 ip dvmrp enable
Command:
ip dvmrp enable
no ip dvmrp
Function:
Configure to enable DVMRP protocol on interface; the “no ip dvmrp” command disenables DVMRP
protocol.
Default:
Disable DVMRP Protocol
Command Mode:
Interface Configuration Mode
Usage Guide:
The interface processes DVMRP protocol messages, only executing DVMRP protocol on interface.
Example:
Enable DVMRP Protocol on interface vlan1.
Switch (config)#interface vlan 1
Switch(Config-If-vlan1)#ip dvmrp enable
44.7.3 ip dvmrp metric
Command:
ip dvmrp metric <metric_val>
no ip dvmrp metric
Function:
Configure interface DVMRP report message metric value; the “no ip dvmrp metric” command
restores default value.
Parameter:
<metric_val> is metric value, value range from 1 to 31
Default:
1
Command Mode: