PLANET XGS3-24042 - Manual (Page 751)

44-26
Default:
Permit the multicast registers from any sources to any groups.
Command Mode:
Global Mode
Usage Guide:
This command is used to configure the access-list filtering the PIM REGISTER packets.The
addresses of the access-list respectively indicate the filtered multicast sources and multicast
groups’ information. For the source-group combinations that match DENY, PIM sends
REGISTER-STOP immediately and does not create group records when receiving REGISTER
packets. Unlike other access-list, when the access-list is configured, the default value is PERMIT.
Example:
Configure the filtered register message’s rule to myfilter.
Switch(config)#ip pim accept-register list 120
Switch (config)#access-list 120 deny ip 10.1.0.2 0.0.0.255 239.192.1.10 0.0.0.255
Switch (config)#
44.3.13 ip pim bsr-border
Command:
ip pim bsr-border
no ip pim bsr-border
Function:
To configure or delete PIM BSR-BORDER interface.
Default:
Non-BSR-BORDER.
Command Mode:
Interface Configuration Mode.
Usage Guide:
To configure the interface as the BSR-BORDER. If configured, BSR related messages will not
receive from or sent to the specified interface. All the networks connected to the interface will be
considered as directly connected.
Example:
Switch(Config-if-Vlan1)#no ip pim bsr-border
44.3.14 ip pim bsr-candidate
Command: