PLANET XGS3-24042 - Manual (Page 353)

19-199
This command is used to configure the IPv4/IPv6 address of tunnel destination.
Example:
Configure tunnel destination 203.78.120.5.
Switch(Config-if-Tunnel1)#tunnel destination 203.78.120.5
19.2.40 tunnel nexthop
Command:
tunnel nexthop <ipaddress>
no tunnel nexthop
Function:
Configure tunnel next hop.
Parameter:
<ipaddress> is the ipv4 address of tunnel next hop.
Command Mode:
Tunnel Configuration Mode.
Default Situation:
There is no IPv4 address of tunnel nexthop.
Usage Guide:
This command is for ISATAP tunnel, other tunnels won’t check the configuration of nexthop. Notice:
IPv4 address of ISATAP tunnel nexthop and IPv4 address of tunnel source should be in same
segment.
Example:
Configure tunnel next hop 178.99.156.8.
Switch(Config-if-Tunnel1)#tunnel source 178.99.156.7
Switch(Config-if-Tunnel1)#tunnel nexthop 178.99.156.8
Switch(Config-if-Tunnel1)#tunnel mode ipv6ip isatap
19.2.41 tunnel mode
Command:
tunnel mode [[gre] | ipv6ip [6to4 | isatap]]
no tunnel mode
Function:
Configure Tunnel Mode.
Parameter: