PLANET XGS3-24042 - Manual (Page 1225)

77-1
Chapter 77 MPLS VPN
77.1 address-family ipv4
Command:
address-family ipv4 [unicast | vrf <vrf-name>| multicast]
no address-family ipv4 vrf <vrf-name>
Function:
Configure the BGP VPN address family; the no operation will cancel the configuration. Before
entering the BGP-VPN view, this VRF should be created and configured with rd.
Parameters:
unicast: unicast address family factor
<vrf-name> : the VPN route/forwarding instance name
Default:
No BGP VPN address family.
Command Mode:
BGP Route Configuration Mode.
Example:
Switch(config)#router bgp 100
Switch(config-router)#address-family ipv4 vrf VRF-A
Switch(config-router-af)#
77.2 address-family vpnv4
Command:
address-family vpnv4 [unicast]
Function:
Configure the BGP VPNv4 address family in non-default mode.
Parameters:
unicast: the unicast address family factor.
Default:
No BGP VPNv4 address family.
Command Mode:
BGP Route Configuration Mode.