PLANET XGS3-24042 - Manual (Page 797)

44-72
Add a Loopback interface as a RP candidate interface based on the original PIM-SM command; the
no operation of this command is to cancel the Loopback interface as a RP candidate interface.
Parameters:
index: Loopback interface index, whose range is <1-1024>.
vlan-id: the VLAN ID.
ifname: the specified name of the interface.
A.B.C.D/M: the ip prefix and mask.
<priority>: the priority of RP election, ranging from 0 to 255, the default value is 192, the smaller
the value is the higher the priority is.
Command Mode:
Global Configuration Mode.
Default Setting:
No RP interface is configured by default.
Usage Guide:
In order to support ANYCAST RP function, new rule allows configuring a Loopback interface to be
the RP candidate interface, the RP candidate interface should be currently unique, and the address
of which should be added into the router to make sure that PIM router can find the nearest RP. The
“no ip pim rp-candidate” command can be used to cancel the RP candidate.
Example:
Configure Loopback1 interface as the RP candidate interface in global configuration mode.
Switch(config)#ip pim rp-candidate loopback1
44.5.6 show debugging pim
Command:
show debugging pim
Command Mode:
Admin Mode.
Usage Guide:
The current state of ANYCAST RP debug switch.
Example:
Switch(config)#show debugging pim
Debugging status:
PIM anycast-rp debugging is on