Ulead 1.0 - Manual (Page 161)

SpruceUp User’s Guide 12—11
Consult the documentation for the drive's software for details on how to do this. Typically
the system must be rebooted for a change in this area to take affect.
Another option is to insert a blank disc prior to starting the export, and cancelling the auto
insert dialog then.
Writing to the Disc
Once a proper disc has been inserted, SpruceUp proceeds with copying the files from the
Working Directory to the disc. The amount of time this takes depends largely on the writing
speed of the drive.
Once completed, the disc is ejected and a message appears indicating the export is
complete.
Note: The files in the Working Directory are not removed until you
perform the next SpruceUp export.
Tip: If for any reason the compile succeeds but the disc write step
fails, you do not need to re-compile to try writing to disc again. If you did
not use the Includes section, set the Source Type setting to Title Set and
choose the Working Directory as the Source Path. If you did use the
Includes section then you can manually copy the contents of the Working
Directory to the disc.
The Source Type Setting
The above assumes Source Type is set to Current Project (the default setting). Setting
Source Type to either Disc Image or Title Set requires you to specify the location of the
files (Source Path). In either case, Disc Image or Title Set, SpruceUp writes the files
directly to the disc without using the Working Directory.
Output To: Title Set
With Output To set to Title Set, SpruceUp compiles the title set and writes it to the folder
specified as the Output Destination. Nothing is written to the Working Directory, and the
Includes section is disabled.
The Source Type Setting
With Output To set to Title Set, the Source Type setting has only Current Project as its
selection.