Ulead 1.0 - Manual (Page 191)

SpruceUp User’s Guide 14—13
The DVD-R SCSI device is not operating properly!
Confirm the DVD-R drive is plugged in, turned on, and the appropriate lights are lit. Shut
the computer down and completely power cycle everything. Ensure the drive is not
overheating. Ensure the latest drivers are installed.
The DVD-R SCSI device is not operating properly! Manual intervention is
needed.
Confirm the DVD-R drive is plugged in, turned on, and the appropriate lights are lit. Shut
the computer down and completely power cycle everything. Ensure the drive is not
overheating. Ensure the latest drivers are installed.
The Enabling Key is invalid.
The Enabling Key value you entered is not valid for this Registration ID. Make sure you
copied the correct numbers and letters.
The frame rate is not DVD compliant. It should either be 29.97 or 25 fps.
Fatal import error. Signifies the frame rate is not either 29.97 (NTSC) or 25 (PAL) as is
supported within the DVD specification. Indicates the file cannot be imported, and must be
re-created compliant with the DVD specification.
The Intervideo player is not working properly!
Indicates the preview decoder used for Simulation and Clip Properties is not operating
properly. See the Minimum System Requirements topic for a list of specific requirements.
The last audio frame is incomplete. Continue parsing will skip this frame
and terminate the parsing normally. The stream will then be used with one
frame less from now on. Otherwise, abort the parsing to correct the
problem. Do you want to continue parsing?
Occurs with MPEG-1 Layer 2 audio files. Non-harmful to continue on.
The media inside the DLT is incompatible with this drive!
Verify the tape being used with the DLT drive to ensure it is correct.
The media inside the DVD-R is incompatible with this drive!
Verify the disc being used with the DVD-R drive to ensure it is correct.
The media is upside down in the DVD-R SCSI drive!
Ensure the disc is oriented correctly before placing it in the DVD-R drive.
The project must be saved before exporting can continue.
You must save the project before you can export it. A project needs to be saved if an
asterisk appears next to its name on the Title Bar along the top of SpruceUp's GUI. Select
File - Save or