Rockwell Automation 2097-Vxxx Kinetix 300 EtherNet/IP Indexing Servo Drive User Manual - Manual (Page 135)

Rockwell Automation Publication 2097-UM001D-EN-P - November 2012 135
Configure and Start Up the Kinetix 300 Drive Chapter 6
Configure the Ethernet Module
This section applies when the ControlLogix controller, catalog number 1756-
ENET/B, is used.
Follow these steps to configure the Ethernet module.
1. Right-click I/O Configuration in
the Controller Organizer and
choose New Module.
The Select Module dialog box opens.
2. Expand the Communications category and select 1756-Exx/x appropriate
for your actual hardware configuration.
In this example, the 1756-ENET/B module is chosen.
3. Click OK.
The New Module dialog box opens.