Rockwell Automation 2097-Vxxx Kinetix 300 EtherNet/IP Indexing Servo Drive User Manual - Manual (Page 84)

84 Rockwell Automation Publication 2097-UM001D-EN-P - November 2012
Chapter 5 MotionView Software Configuration
Drive Organizer and
Identification On the left side of MotionView software is the Drive Organizer. The Drive
Organizer displays the node address for the drives that are currently connected to
the software and lists the categories for each drive under the drive node address.
This section contains a description of the parameters displayed in each category
listed in the Drive Organizer.
Drive Identification displays the drive IP address and status. The dialog box
displays drive identification information such as catalog number and firmware
revision. In this window, you can assign the Drive Name and the Group ID.
Table 36 - Drive Identification Category
Motor Category Allen-Bradley motors and actuators with intelligent feedback devices are
automatically populated into the motor configuration. In this example, no motor
is attached to the drive.
Drive Identification
Drive
Organizer
ID Parameter Name Description Value/Notes
1 Drive ID String Drive identification string
2 Drive Name Drive symbolic name Up to 20 user-defined characters
3 Serial Number Drive serial number Unique number assigned to drive at the factory
57 Group ID Network group ID. Allows the assignment of
different drives into logical groups. Range: 1…32767
N/A Motor Database Revision The motor database resides in the drive firmware. 006 in this example
B12 154 140 100 020
Device Firmware Hardware Deviation
Family Revision Revision Revision
Vector
Processor
Revision