Rockwell Automation 2097-Vxxx Kinetix 300 EtherNet/IP Indexing Servo Drive User Manual - Manual (Page 60)

60 Rockwell Automation Publication 2097-UM001D-EN-P - November 2012
Chapter 4 Connecting the Kinetix 300 Drive System
Single-phase Power Wired to Single-phase Drives
These examples illustrate grounded single-phase power wired to single-phase
Kinetix 300 drives when phase-to-phase voltage is within drive specifications.
Figure 35 - Single-phase Grounded Power Configurations
(1) This configuration applies to voltage-doubler operation for 2097-V31PRx drives.
Reducing transformer output reduces motor speed. Feeder and branch short
circuit protection is not illustrated.
Voltage Doubler Operation
You can wire the 2097-V31PR
x drives with 120V input power and achieve twice
the output voltage at half the output current, while maintaining the same output
power. To use the voltage-doubler circuit, connect the 120V single-phase input
power to the IPD-L1 and IPD-N terminals.
For Kinetix 300 drive power specifications, see Kinetix Servo Drives
Specifications Technical Data, publication
GMC-TD003 . For Kinetix 300 drive
input wiring diagrams, see Power Wiring Examples on page 173 .
IMPORTANT The 2097-V32PRx models have integrated AC line filters and do not require the
AC line filter shown in this diagram.
L1
L2
L1
L2 (Neutral)
IPD
L1
L2/N
L1
L2/N
L1
N
E
IPD
L1
L2
L1
L2
L1
L2/N
E
IPD
L1
L2
IPD
L1
L2
2097-V33PRx
2097-V31PRx 2097-V32PRx Transformer Secondary
Transformer Secondary
Bonded Cabinet Ground Bus
Ground Grid or
Power Distribution Ground
AC Line
Filter
AC Line
Filter 120V AC
Output
240V AC
Output
Bonded Cabinet Ground Bus
Ground Grid or
Power Distribution Ground
Kinetix 300 Drives
Single-phase AC Input
Kinetix 300 Drives
Single-phase AC Input
M1
Contactor
Input Fusing
M1
Contactor
Input Fusing
2097-V31PRx
(1)