Bio-Rad iQ™5 Optical System Software, Version 2.1 - Manual (Page 3)

- ii -
Safety Information
Grounding
Always connect the MyiQ TM 2, MyiQ TM , or iQ TM 5 optics module to a three-prong, grounded AC outlet
using the AC power cord provided with the system. Do not use an adaptor to a two-terminal
outlet. Always ensure that you set the module power switch to the off position when you connect
or disconnect power cords.
Handling
Handle all components of the real-time PCR detection system with care and with clean, dry hands
at all times. The optical system contains mirrors and lenses that may shatter if the unit is
dropped or struck with great force. If the unit is damaged such that internal components or wires
are exposed, contact your local Bio-Rad office immediately. Do not attempt to repair or power on
the instrument.
Servicing
The only user-serviceable parts of the optics module are the lamp and filters. Call your local
Bio-Rad office for all other optics module and thermal cycler related service. When you replace
the lamp or filters, open only the outer casing of the optics module. The camera lamp may get
extremely hot during system operation. Do not attempt to remove the lamp without powering off
the instrument and allowing the system to cool for at least 15 minutes. To prevent skin burns
and fire hazards, do not attempt to operate the real-time PCR detection system while the camera
case is open. Do not open casing of the optics module when the instrument is in use.
Operating Temperature
For normal operation, the maximum ambient temperature should not exceed 40°C. To ensure
adequate cooling of the system, maintain a clearance of at least 4 inches around the sides of the
MyiQ2, MyiQ, or iQ5 optics module. Do not block the fan vents near the lamp, as this may lead to
improper operation or cause physical damage to the detector. Do not operate the optics module
in extreme humidity (that is, greater than 90 percent) or where condensation can short internal
electrical circuits or fog optical elements.
Notice
The MyiQ2, MyiQ, and iQ5 instruments are designed and certified to meet EN-61010 safety
standards.
EN-61010 certified products are safe to use when operated in accordance with the instruction
manual. These instruments should not be modified in any way. Alteration of the instruments will:
•
Void the manufacturer’s warranty
• Void the EN-61010 safety certification
• Create a potential safety hazard
Bio-Rad is not responsible for any injury or damage caused by the use of these instrument for
purposes other than those for which they are intended, or by modifications to the instruments
not performed by Bio-Rad or an authorized agent.