Bio-Rad iQ™5 Optical System Software, Version 2.1 - Manual (Page 69)

Section 6 Data Analysis Module
- 60 -
Start and Ending Cycle Mode
To change the baseline range for all wells, click Select All. Then click Edit Range to enter the
start and end cycle for baseline calculation (Figure 6.16).
To change the baseline for individual wells, click on a well and then click Edit Range to enter
the start and end cycle for baseline calculation.
Fig. 6.16. The Both Start and Ending Cycle Mode.
Start Cycle Only Mode
By default both the start and ending cycle for baseline calculation are altered. If you select the
Start cycle only mode, you can only edit the Start Cycle box. This mode is useful if you want to
retain the automatically determined end cycle but wish to change the value of the start cycle.
Enter the desired value for the start cycle for the selected traces and then click OK (Figure 6.17).
Select individual wells or all wells as described above.
Fig. 6.17. The Start Cycle Only Mode.
Ending Cycle Only Mode
In the Ending cycle only mode, you can only edit the Ending Cycle box. This mode is useful if
you want to retain the automatically determined start cycle but wish to change the value of the
end cycle. Enter the desired value for the end cycle for the selected traces and then click OK
(Figure 6.18). Select individual wells or all wells as described above.