PRG V676 User Manual 3.5 - Manual (Page 106)

88 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Dynamics
When [Dynam] is selected, the soft encoder mapping is as follows:
RATE (5 sec / +1 sec)
w/ [Shift] button pressed - RATE (5 sec / -1 sec)
w/ [Fan] button pressed - RATE (5 sec / fan +1 sec)
This encoder changes the rate of a dynamic on parameters selected in the Filter window. CCW speeds up
the rate, while CW slows the rate down. The rate can also be fanned.
SIZE (default / autoFit)
This encoder changes the size of a dynamic on parameters selected in the Filter window. CCW decreases
the size, while CW increases the size. The size can also be fanned.
autoFit - automatically chooses the maximum size dynamic.
OFFSET (min / +120)
w/ [Shift] button pressed - OFFSET (min/-180)
w/ [Fan] button pressed - OFFSET (min/fan +180)
This encoder is used to determine where along the waveform, the dynamic should start. The Offset is
measured in degrees where a complete waveform is 360 degrees (1 cycle). This function can be used to
create "multi" looks when the offset is fanned across channels. (Note that the minimum is 0 degrees.)
Refer to the "Dynamics" chapter on page 171 for more information about using the encoders with dynamics.
Frame
When [Frame] is selected, the soft encoder mapping is as follows:
ROTATE
[mid] - sends framing mechanism back to its mid-point.
[rot 90] - rotates framing mechanism 90 degrees from its current position.
ALL
[flip H] - flips framed image to a horizontal position.
[flip V] - flips framed image to a vertical position.
SHUTTER 4
Button [max] selects Encoder 4 and controls both motors to bring the shutter in.
Button [min] selects Encoder 4 and controls both motors to take the shutter out.
SHUTTER 3
Button [max] selects Encoder 3 and controls both motors to bring the shutter in.
Button [min] selects Encoder 3 and controls both motors to take the shutter out.
SHUTTER 2
Button [max] selects Encoder 2 and controls both motors to bring the shutter in.
Button [min] selects Encoder 2 and controls both motors to take the shutter out.
SHUTTER 1
Button [max] selects Encoder 1 and controls both motors to bring the shutter in.
Button [min] selects Encoder 1 and controls both motors to take the shutter out.