PRG V676 User Manual 3.5 - Manual (Page 341)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 323
PLAYBACK
Advanced Playback of Cues
A cue loaded into a submaster becomes the pending cue. When [Go] is pressed, the pending cue will play.
Play a cue:
Step 1. At keypad, press [Cue] [n] [Enter] or scroll through cue list to select cue. It will be displayed in the keypad
window.
Step 2. At required submaster, press [Select] to select
submaster for playback function.
Step 3. Press [Load] to place cue in pending file (as shown in
submaster display).
Step 4. Set Grand Master fader at required level.
Step 5. Set submaster fader at required level.
Step 6. Press [Go] to play cue.
Play next cue:
The submaster always sequences, placing the next sequential
cue from the cue sheet or any linked cue in its pending file.
Linked cues without wait times will await manual execution.
+ Press [Go] again to play next cue.
Play previous cue:
+ Press [Back] to play previous cue (previously active on that
submaster). Subsequent presses of [Back] will step
backwards through cue sheet.
Play a cue again:
+ Press [Run] to play active cue again.
If submaster is empty: at keypad press [cue number], then at submaster press [Go]. (Must be valid cue
number.)
set cue 1
Cue 1 *
1
Select
Load
Run
Stop/
Step
Back
Go
Solo
Bump
Loads cue
Plays active cue
Plays pending cue
Plays last cue
Scales intensity
Active cue
Pending cue
Stops/Steps
Selects submaster
Submaster Fader
Momentary submaster select
(all others go to zero)
Submaster
Attributes
Shows autofollow time, or
cue execution time if no
autofollow is specified.
through cues Shows autofollow
time, or cue execution
time if no autofollow is
specified
Status:
R = running
S = stopped
Tip