PRG V676 User Manual 3.5 - Manual (Page 288)

270 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Delete a step:
Step 1. Using trackpad, select step(s) to be deleted.
Step 2. Click on "trash can" icon. Step(s) will be removed.
Replace a step:
Step 1. Using trackpad, select step to be replaced.
Step 2. Click "replace" icon. [Board Cue Record] button will begin to flash.
Step 3. At front panel, perform replacement action. (The first action taken will replace the selected step and editing
will end.)
Replace all steps from Step X on (through remainder of Board Cue):
Step 1. Using trackpad, select last "good" step. (Steps after this selection will be replaced.)
Step 2. Click "punch in" icon. [Board Cue] button will begin flashing.
Step 3. At front panel, perform new series of actions.
Note: Board Cue can be updated or re-stored as a new number.
Step 4. Store by one of the following methods:
a. To store back into original number, press [Update] [Board Cue] [Enter].
b. To store into new number, press [Store] [Board Cue] [n] [Enter] or [Store] [Board Cue] [n] [Label] [Enter]

xxxxxx

Enter/Accept

.
Insert new step(s):
Step 1. Using trackpad, select step prior to where you wish to insert new step.
Step 2. Click "insert" icon. [Board Cue Record] button will begin to flash.
Step 3. At front panel, perform new step(s).
Step 4. Store by one of the following methods:
a. To store back into original number, press [Update] [Board Cue] [Enter].
b. To store into new number, press [Store] [Board Cue] [n] [Enter] or [Store] [Board Cue] [n] [Label] [Enter]

xxxxxx

Enter/Accept

.