PRG V676 User Manual 3.5 - Manual (Page 296)

278 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Cue Store Target
Pressing [Store] [Enter] always defaults the store command to the last selected cue. (This cue is displayed in the
command-line display.)
Additionally, when working with decimal cues, it is not necessary to re-enter the leading cue number.
Examples:
+ [Store] <Cue> [5] [Enter] = store Cue 5
+ [Store] <Cue> [5] [.] [3] [Enter] = store Cue 5.3
+ [Store] <Cue> [.] [7] [Enter] = store Cue 5.7
Cue Attribute Target
For the currently selected cue (see illustration above), attribute instructions can be applied without re-specifying the
cue target.
Examples:
+ To link another cue to the currently selected cue, press [Link] [n] [Enter] - where n is the linked cue.
+ To link a snapshot, macro, or effect to the currently selected cue, press [Link] [Macro*] [n] [Enter] - where n is the
number of the macro you wish to link.
* [Snap Shot] or [Effect] can be used instead of [Macro].
+ To add a wait/trail time, out time, or loop to the currently selected cue, press [Wait*] [n] [Enter] - where n is desired
time or number of loops.
* also [Trail], [Out Time], or [Loop].
Miscellaneous Shortcuts
+ Holding down [Clear] will clear an entire unterminated command line.
+ Pressing and holding [Next] while pressing [Last] will reselect the original channel range or group.
Creating Cue Numbers without Storing Data
It is possible to create and label cues without storing data. To do this is, store a cue while all luminaires are inactive or
off-line.
Selected Cue
[Store] [Enter] will always re-store this cue