PRG V676 User Manual 3.5 - Manual (Page 160)

142 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Storing and Recalling Colors
Note: Beams and Colors are global settings by luminaire type. During a store operation, the parameters that are
stored will be drawn from either the lowest
active luminaire or lowest selected luminaire as determined by the
console’s default setting (refer to "System-Wide Palette Store Options" on page 127).
From Palettes
Store a new color using Colors palette:
Step 1. Ensure color you wish to store is displayed in lowest active luminaire channel (for each luminaire type), if the
default "lowest active channel" has not been changed (refer to "Settings Window" on page 328).
Step 2. Ensure Colors are selected on at least one palette. (Refer to page 130 .)
Step 3. Select required bank and select page.
Step 4. Press and hold [Store] while pressing

Color Palette Button

.
Store a new color using command-line keypad:
Step 1. Ensure color you wish to store is displayed in lowest active luminaire channel (for each luminaire type), if the
default "lowest active channel" has not been changed (refer to "Settings Window" on page 328).
Step 2. Press [Store] [Color] [n] [Enter] (where n is the discrete Color number).
Label an existing color, page, or bank:
When labeling, the name can be entered on the console touchscreen keyboard or computer keyboard.
Step 1. Ensure Colors are selected on at least one palette. (Refer to page 130 .)
Step 2. Press and hold [Label] while pressing any Color bank, page, or palette button.
Step 3. Enter alpha/numeric label.
Recall a color using Colors palette:
Step 1. Select required channels.
Step 2. Ensure Colors are selected on at least one palette. (Refer to page 130 .)
Step 3. Press required

Color Palette Button

.
Recall a color using command-line keypad:
Step 1. Select required channels.
Step 2. Press [Color] [n] [Enter] (where n is the discrete Color number).
Note: Channels that are selected during a color recall that have no value for that color will remain in their current
state.
From Keypad
Store a new Color:
Step 1. Select required channels.
Step 2. Using manual controls, set all required parameters.
Step 3. Press [Store] [Color] [n] [Enter] or [Store] [Color] [n] [Label] [Enter]

xxxxxx

Enter/Accept

(where n is the
discrete Color number).
Delete a Color:
+ [Delete] [Color] [n] [Enter]. The display will now show this as an "empty" Color.