PRG V676 User Manual 3.5 - Manual (Page 200)

182 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Storing Dynamics in Cues/Presets
Canned or custom dynamics can be added to the parameters stored in cues or presets. To store a dynamic without
any base values, a palette must be used (see below).
Guidelines:
+ Fixture parameters use parameter time to perform transitions into or out of dynamic states, such as rocks or
ballyhoos.
+ The same time value is used for the parameter value transition and the dynamic transition.
+ Transitioning between different types of dynamics may not always be smooth.
To store in a cue:
+ Store cue using normal cue storing operations. (Refer to "Creating Cues" on page 162.)
To store in a preset:
When storing in a preset, you must first select the parameters in the Function Filter and then press

Dynamic

.
Step 1. Open Function Filter by pressing "filter" in central touchscreen. (Refer to "Function Filter" on page 115.)
Step 2. Select parameter(s) to be stored.
Step 3. At right side of Function Filter, press

Dynamic

button.
Step 4. Store preset as usual. (Refer to "Storing, Modifying, and Recalling Presets" on page 137.)
Storing Dynamics in Macros
Complex dynamics can also be stored as macros. For example, press [Store] [Macro] [Enter] at command-line
keypad, then create a dynamic. When complete, press [Store] [Macro] [n] [Enter] - where n is the number of the macro
palette where you wish to store the recorded sequence.
Refer to "Macros" on page 255 for more information about recording macros.
Dynamic
Button
Selected Parameter (highlighted)