PRG V676 User Manual 3.5 - Manual (Page 127)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 109
General Operations
Operation of the Timing Filter and Function Filter can be done from the central touchscreen (available on the front
panel) or the Timing/Filter Display window (available from the Operation menu). The operations are basically identical
whether you are using the touchscreen or software window.
To select the mode:
To open the Timing Filter or Function Filter, press the appropriate button at the bottom of the touchscreen. Only one
mode is visible at a time, although in the case of the Function Filter, it does not have to be visible for selected filters to
affect console operation.
Note: If a store command is initiated while the touchscreen is in the Timing Filter, then the screen will automatically
switch to the Function Filter until the store operation is complete.
To set parameters:
Select parameters by touching the appropriate location on the screen, and when necessary, enter values using the
command-line keypad.
Depending on the current function,

Time Filter Enter

or

Function Filter To Cue

must be pressed before the settings
will be applied to store or playback operations.
Templates:
The template section, found at the bottom of both the Timing Filter and Function Filter screens, provides 20
programmable templates that can be used to store frequently used settings.