PRG V676 User Manual 3.5 - Manual (Page 229)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 211
PLAYING BACK EFFECTS
Basic Playback
After creating an effect, it can be played back using a submaster. (If a duration or cycle count is not specified, the
effect will run until stopped.)
Play an effect:
Step 1. At keypad, press [Effect] [n] [Enter] - where n is the
desired effect number. (It will be displayed by number
and label in command-line display.)
Step 2. At desired submaster, press [Select].
Step 3. Press [Load] to place effect in submaster’s pending
file.
Step 4. Ensure Grand Master fader is set at full.
Step 5. Ensure submaster fader is 100%.
Step 6. Press [Go] to play effect. Display will indicate set,
sequence, and step numbers as they run.
Step 7. Press [Run] to replay effect once it is active.
Play next effect:
The submaster always sequences, placing the next available
effect in the pending file.
+ Press [Go] to play back pending effect.
Play previous effect:
The submaster can play back previously played effects in
decrementing order.
+ Press [Back] to play previous effect.
Stop/Step:
A running effect can be stopped and then stepped through one
step at a time.
Step 1. Press [Stop/Step] to stop a running effect.
Step 2. Press [Stop/Step] repeatedly to step through effect.
Step 3. Press [Run] to resume playback.
1
Select
Load
Run
Stop/
Step
Back
Go
Solo
Bump
Loads effect
Plays active effect
Plays pending effect
Plays last effect
Scales intensity
Active effect
Pending effect
Stops/Steps through effect
Selects submaster
Submaster
Momentary submaster select
(all others go to zero)
Step execution
and timing
Status -
R = running
S = stopped
Set & Sequence
Fader