PRG V676 User Manual 3.5 - Manual (Page 337)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 319
Function Filter (Submaster)
The Function Filter applies filters to a submaster for modification of a cue or effect during playback. The submaster
Function Filter mode works in conjunction with the console’s Function Filter (refer to
"Function Filter" on page 115).
Guidelines:
+ The function filter does not become active until the next event is recalled.
+ If a cue has a mask associated with it, the submaster filter state will override the mask. (All parameters will be
played back, whether or not they were originally intended for playback when the cue was stored.) Refer to
"Masking" on page 116.
+ If filters are modified at the Function Filter after initially assigning to a submaster, you must reapply the Function
Filter to update the filter changes in the submaster.
+ Filters can be used with Effects to withhold information from cues, beams, and presets when they are part of an
effect sequence. When cues are included in sequences, the cue times are used instead of attack times, unless
timing is disabled in the filter selection.
Apply function filters using submaster touchscreen:
Step 1. Choose a submaster to bring up its Setup options. ("Choose" is activated by touching the specific
submaster on the touchscreen.)
Step 2. Select

Function Filter

checkbox.
Step 3. Press

Close

to close Setup screen.
To release function filters using submaster touchscreen:
Step 1. Choose a submaster to bring up its Setup options. ("Choose" is activated by touching the specific
submaster on the touchscreen.)
Step 2. Deselect

Function Filter

checkbox or press

Clear

to clear all submaster settings.
Step 3. Press

Close

to close Setup screen.
Function Filter
Filters