PRG V676 User Manual 3.5 - Manual (Page 334)

316 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Manual Assign
The Manual Assign feature loads any selected channels and their current parameter settings into the submaster for
control. The submaster fader can then be used to scale the intensity output for those channels. For example, this
function could be used to adjust the intensities of specific luminaires in order to brighten or dim certain areas of a
stage.
When channels are manually assigned to a submaster, the current cue or stage look associated with those channels is
now controlled by the submaster fader until such time as the manual assignments are cleared from the submaster, a
new cue is played, or a manual control action is made at the Manual Control panel.
Guidelines:
+ Channels/parameters can be taken away from the submaster when a new command is issued by a playback,
unless the submaster is in independent mode (refer to "
Independent" above).
+ Manual assignments will be cleared when a new cue is played back on that submaster; the channels will fade out
in the out fade time of the incoming cue or effect.
+ If filters are being used with the submaster, they will modify the manually assigned channels accordingly (refer to
"Function Filter (Submaster)" on page 319).
+ The submaster must first be selected before assigning manual control. (All other submaster functions can be set
without selecting the submaster.)
+ Channels may be added by manual assignment to a submaster that has channel filters. However, this does not
add those channels to the list of filtered channels (refer to
"Channel Filter" on page 318).
Manually assign a channel, range of channels, or group using submaster touchscreen:
Step 1. Select required channels.
Step 2. Choose a submaster to bring up its Setup options. ("Choose" is activated by touching the specific
submaster on the touchscreen.)
Step 3. Press

Manual Assign

.
Step 4. Press

Close

to close Setup screen.
Assign new channels to a previous manual assignment using submaster touchscreen:
The Manual Assign function is an additive process which will allow you to add channels to an existing manual
assignment.
Step 1. Select new channels.
Step 2. Choose a submaster to bring up its Setup options. ("Choose" is activated by touching the specific
submaster on the touchscreen.)
Step 3. Press

Manual Assign

.
Step 4. Press

Close

to close Setup screen.