Playback using the grab feature, Current selection – PRG V676 User Manual 3.5 User Manual
Page 187
V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
169
Playback Using the Grab Feature
Note: The Grab feature was added with Vx76 software version 2.0. The previously unused [Fan Type] button on the
command keypad was replaced with a [Grab] button.
Grab provides the capability to withhold functions of a channel from playback. When a channel is "grabbed," the
current function filter will determine which parameters are affected. These parameters will respond normally to all
manual commands, but will not respond to any submaster control.
Grab is initiated from the command line. When the [Grab] button is pressed, the function filter will automatically open
(as with Selective Store), to highlight the fact that the filter applies to Grab and to allow setting of the desired state.
The Grab selection can be set in various ways, including command line and control key combinations. All normal
selection rules apply in terms of additive and exclusive selects. For example, [Grab] [1] [Thru] [5] [Enter] will result in
channels 1-5 being the only grabbed channels (just like selection would work). [Grab] [+] [1] [Thru] [5] [Enter] would
add channels 1-5 to the grab selection.
Using with the command line:
+
[Grab] [Enter] - Sets the grab selection to current selection (all others ungrabbed). If no channels selected, it
would ungrab all.
+
[Grab] (channel select expression) [Enter] - Sets grab selection to expression (all others ungrabbed)
+
[Grab] [0] [Enter] - Sets grab selection to none (ungrabs all).
+
[Grab] [+] (channel select expression) - Grabs additional channels (others are unaffected).
+
[Grab] [-] (channel select expression) - Ungrabs specified channels (others are unaffected).
When channels are grabbed, the channels specified by the grab command will become the
current selection
. For
example, if channels 1-10 are selected and [Grab] [20] [Enter] is input on the command line, then Channel 20 will be
selected and channels 1-10 deselected.
Using with other keys:
+
[Grab]+[submaster choose] - Grabs channels controlled by the submaster (all others ungrabbed). ("Choose" is
activated by touching the specific submaster on the touchscreen.)
+
[Grab]+[group select] - Grabs channels in group (all others ungrabbed).
When Grab is used as a control key, it will be automatically dismissed on the command line as with other control keys
like [Store]. For example, [Grab]+[group select].
Showing the grab selection:
+
[Group] [Grab] [Enter] - Sets selection to current grab selection.
+
-
9
8
7
4
5
6
3
2
1
.
0
Store
Sel
Store
Recall
Label
Delete
Update
Grab
Track/
Fill
Park/
Unpark
Undo
Patch
Sneak
Help
Copy/
Move
?
Cue
Chan
Dimmer
Board
Cue
Macro
Snap
Shot
Preset
Color
Beam
Effect
Set
Seq
Group
Dynam
Step
Clear
Link
Loop
Out
Time
Wait
Trail
Rate
Time
Block
Sub
Delay
Speed
At
Full
Enter
Thru
Cmd
Option
Shift