Fan mode – PRG V676 User Manual 3.5 User Manual
Page 110
92
V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
Fan
The Fan function allows "fanning" of any encoder-controlled parameter across multiple channels. For example, it
could be used to "fan" a dynamic across a group of luminaires in order to achieve a more random effect. It does this
by giving each channel an "offset" starting point so that each luminaire starts the action at a different time (instead of
simultaneously).
There are five fan mode types: Left fan, Right fan, Center fan, Ends fan, and Tilt fan. Each type uses a different anchor
point for the base of the fan. Fan ordering is determined by selection order.
The fan mode can be changed from two locations: the Special menu or the front panel. These operations are as
follows:
1)
At Special menu, select Encoder Fan, then choose the mode.
2)
At front panel, press
fan mode
button, then choose the mode.
Once the fan mode is chosen:
+
At front panel, press and hold [Fan] button while turning an encoder. Double-clicking the [Fan] button will latch fan
mode on (LED will flash). Double-click again to turn fan mode off.
Note: Timing and delay attributes can be "fanned" into channel selections using the soft encoders or command-line
keypad. Refer to
on page 114 for more information.
1
2
4
3
5
8
6
7
11
12
14
13
15
18
16
17
Fan
Effect
Frame
Image
Slow
3D
Beam
Shift
Grid
Dynam
Color
Front Panel
Fan Button
2
Encoder Fan Menu
1