PRG V676 User Manual 3.5 - Manual (Page 215)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 197
Set 0 (all patched channels) will be loaded into part 1 of the Set.
All attributes and timing will be in the default setting.
Step 4. Create a Set:
a. Select required channels.
b. Press

Interlaced/Sequential

button to select method of loading. (Also refer to "Set: Interlaced vs.
Sequential" on page 198.)
c. Press and hold [Set Channels] or [Store] while selecting first part (for example, p1), then while
continuing to hold [Set Channels] / [Store], drag finger across touchscreen until last part is reached (for
example, p6). Release [Set Channels] / [Store] button. This will specify the range of parts that will
contain the channels. Channels will load across parts according to the method chosen (Interlaced or
Sequential).
Important! In order to properly load the channels across the parts, you must drag your finger across the
touchscreen. Pressing the first part button, then pressing the last part button will not work.
Note: Parts can be loaded in reverse order by dragging finger across the touchscreen in the reverse direction . For
example, press and hold [Set Channels] or [Store] while selecting

p6

, then while continuing to hold [Set Channels] /
[Store], drag finger across touchscreen until

p1

is reached. Release [Set Channels] / [Store] button.
Note: To create a Set with more than seven parts, it will be necessary to use the Set Edit screen. Refer to "Using the
Set Edit Screen" on page 214.
Step 5. Create a Sequence:
a. Press [Load Step] button (at right of screen). (Button will flash and text will turn red.)
b. Using palettes (Preset, Color, Beam, etc.) fill steps with actions. (Selection will automatically advance to
the next step after an action is loaded.)
Note: Up to three actions can be stored in single step. To specify additional actions, select the step again and add
the new action.
c. Press [Cancel Load Step] button. (Button will stop flashing and text will turn to white.)
d. If desired, select a Background State. (Refer to "Sequence: Background State" on page 199.)
Note: To create a Sequence with more than seven steps, it will be necessary to use the Sequence Edit screen. Refer
to
"Using the Sequence Edit Screen" on page 215.
Step 6. Label effect. (When labeling, the name can be entered on the console touchscreen keyboard or computer
keyboard.)
a. Press and hold [Label] while pressing

Effect Select Button

.
b. Enter alpha/numeric label.