From keypad, Guidelines, Order – PRG V676 User Manual 3.5 User Manual
Page 96: V476, Control console user manual, Ready (channel) tip
78
V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
From Keypad
Channels may also be selected using the command-line keypad, available on the front panel.
Guidelines:
+
Any combinations of [ + ], [ - ], and [Thru] are
allowed.
+
Pressing [Enter] completes the channel selection.
+
Because the keypad always defaults to channel
entry mode, use of the [Chan] (channel) button is
optional.
Select a single channel:
+
<Chan> [n] [Enter].
Select multiple channels:
+
<Chan> [m] [+] [n] [Enter].
Select a range of channels:
+
<Chan> [m] [Thru] [q] [Enter].
Select multiple channels including a group:
+
<Chan> [m] [+] [Group] [n] [Enter].
Select all active channels:
+
[Chan] [Enter].
Other examples:
+
<Chan> [m] [+] [s] [Thru] [w] [Enter].
+
<Chan> m] [+ ] [s] [Thru] [w] [-] [t] [Enter].
[Clear]
[Clear] functions as a backspace key when used during command-line construction. For example, <Chan> [n] [Thru]
[t] [Clear] [s] [Enter] results in the selection of channels n thru s. When [Clear] is used after an [Enter] (fully terminated
command line), the command line is cleared.
The only thing that clears a syntax error on the command line is [Clear]. Any other keypad entry is ignored until the
error condition is cleared.
Holding down [Clear] will clear an entire unterminated command line.
Note: The
order
of channel selection is retained when storing a Group. Refer to
+
-
9
8
7
4
5
6
3
2
1
.
0
Store
Sel
Store
Recall
Label
Delete
Update
Grab
Track/
Fill
Park/
Unpark
Undo
Patch
Sneak
Help
Copy/
Move
?
Cue
Chan
Dimmer
Board
Cue
Macro
Snap
Shot
Preset
Color
Beam
Effect
Set
Seq
Group
Dynam
Step
Clear
Link
Loop
Out
Time
Wait
Trail
Rate
Time
Block
Sub
Delay
Speed
At
Full
Enter
Thru
Cmd
Option
Shift
ready (channel)
Tip