PRG V676 User Manual 3.5 - Manual (Page 164)

146 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
Storing, Modifying, and Recalling Beams
Note: Beams and Colors are global settings by luminaire type. During a store operation, the parameters that are
stored will be drawn from either the lowest
active luminaire or lowest selected luminaire as determined by the
console’s default setting (refer to "System-Wide Palette Store Options" on page 127).
From Palettes
Store a new Beam using Beams palette:
Step 1. Select required channels.
Step 2. Ensure Beams are selected on at least one palette. (Refer to page 130 .)
Step 3. Using manual controls, set all required parameters.
Step 4. Using Function Filter, filter parameters as required. (Refer to "Function Filter" on page 115.)
Step 5. Press and hold [Store] while pressing

Beam Palette Button

or [Store] [Label] /

Beam Palette Button


xxxxxx

Enter/Accept

.
Note: Parameters stored into a Beam palette are always determined by the filters (refer to "Function Filter" on
page 115).
Store a new Beam using command-line keypad:
Step 1. Select required channels.
Step 2. Using manual controls, set all required parameters.
Step 3. Filter attributes as required using touchscreen display.
Step 4. Press [Store] [Beam] [n] [Enter] or [Store] [Beam] [n] [Label] [Enter]

xxxxxx

Enter/Accept

(where n is the
discrete Beam number).
Label an existing Beam, page, or bank:
When labeling, the name can be entered on the console touchscreen keyboard or computer keyboard.
Step 1. Ensure Beams are selected on at least one palette. (Refer to page 130 .)
Step 2. Press and hold [Label] while pressing any Beam bank, page, or palette button.
Step 3. Enter alpha/numeric label.
Add a new luminaire type to a Beam:
If you are modifying a Beam by storing a new type of luminaire(s), then the new data will be added to the existing data.
Step 1. Select required channel(s). (The channel should contain at least one different luminaire type than currently
stored in the Beam.)
Step 2. Ensure Beams are selected on at least one palette. (Refer to page 130 .)
Step 3. Using manual controls, set all required parameters.
Step 4. Using Function Filter, filter parameters as required. (Refer to "Function Filter" on page 115.)
Step 5. Press and hold [Store] while pressing

Beam Palette Button

or [Store] [Label] /

Beam Palette Button


xxxxxx

Enter/Accept

.