PRG V676 User Manual 3.5 - Manual (Page 311)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 293
Editing specific lines:
+ When editing a specific line of a cell, standard Mac computer text copy and paste rules will apply.
Selection:
+ To select a cell, click on it.
+ To extend or shrink the current cell selection(s) in a rectangular fashion, hold down the Mac keyboard SHIFT key
and click on another cell.
+ To add or remove a specific cell, hold down the Mac keyboard WIN key and click on that cell.
Copying:
+ Any selection may be copied to the clipboard. All lines of every selected cell are placed on the clipboard. (Value,
Parameter Source, Timing, Dynamic). This includes lines that you may have hidden by using the Parameter
Columns window.
Pasting (General):
+ When data is pasted into a cell, all contents of the destination cell are completely replaced with the contents of
the cell on the clipboard. The exception would be if data for a line is out of range, in which case it is ignored.
However, only those particular lines that are out of range are ignored. The rest of the cell pastes normally.
+ Any parameter may be pasted over any other parameter. Range checking will be performed to prevent data
corruption.
+ In general, it is not possible to edit, copy, or paste any parameter column that is not in the table. The exception is
the Focus and Color columns. Pasting into one of these columns is equivalent to pasting the same cell into ALL of
its component columns. This will occur whether or not the component columns have been selected in the
Parameter Columns window.
Pasting (One-To-Many)
+ If only one cell is resident on the clipboard, the contents of that one cell will be pasted into all selected cells.
Pasting (Many-To-Many)
+ If more than one cell is resident on the clipboard, the following method is used.:
Data is pasted in Row by Row. There is a 1:1 mapping of rows in the clipboard to rows in the selection. If there are
more rows in the selection than there are in the clipboard, nothing will be pasted into these rows. If there are fewer
rows in the selection than on the clipboard, the remaining rows in the clipboard will be ignored.
Note: This same logic is applied to extra cells in the clipboard or selection for each row.
Cue Data Find/Replace
The Find/Replace function can also be used for spreadsheet editing.
CAUTION: Be sure no edits have been made in the window prior to starting this process.
Note: The cue in which edits are being made must be selected on the front panel cue sheet and channels that are
being changed must be selected after edits.