PRG V676 User Manual 3.5 - Manual (Page 325)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 307
IFCB Faders
The IFCB faders use existing submaster priority concepts to allow manual crossfading between an IFCB fader cue
and a lower priority state. While in IFCB mode, all controlled parameters (as defined by the normal channel and
function filter) in the active cue will interpolate their positions between the current submaster state and the next lower
priority state (as defined by normal priority rules).
For example, Sub 1 is running at priority 0, and Sub 2 is set up as an IFCB fader at priority 10 (all parameters, all
channels). If Sub 2 is selected with its fader all the way down, there is no change on stage. As the Sub 2 fader is
raised, all affected parameters will move towards the goal of the active cue in Sub 2. Once the Sub 2 fader is all the
way up, the lower priority data is no longer used.
Note: Timing is ignored unless the fader is at full or zero, in which case the higher priority or lower priority values are
used, respectively.
When IFCB mode is active, the function filter grid will be highlighted in blue:
To set IFCB mode using submaster touchscreen:
Step 1. Choose a submaster to bring up its Setup options. ("Choose" is activated by touching the specific
submaster on the touchscreen.)
Step 2. Select

IFCB Mode

checkbox.
Step 3. Press

Close

to close Setup screen.
To release a submaster from IFCB mode using submaster touchscreen:
Step 1. Choose a submaster to bring up its Setup options. ("Choose" is activated by touching the specific
submaster on the touchscreen.)
Step 2. Deselect

IFCB Mode

checkbox or press

Clear

to clear all submaster settings.
Step 3. Press

Close

to close Setup screen.