PRG V676 User Manual 3.5 - Manual (Page 173)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 155
Arrangement Tab
The Arrangement tab defines the components of a group. These are arranged as an ordered parts list, broken into
divisions (if multiple divisions have been set). The top of the window provides controls to change how channels get
arranged or distributed within the group. The arrangement can be applied automatically (according to the settings) or
programmed manually. (Programming the Arrangement manually is similar to programming Effect Sets.)
+ Automatic/Manual - Automatic specifies that the arrangement will follow the settings for Order, Layout,
Allocation, and Direction. Manual allows the channels to be manually stored into individual divisions.
- Note that channels cannot be stored to an automatically arranged division. If the channels are "None," the tab
switches to the Automatic arrangement.
- Manual will be disabled if channels are rule-based since the group’s channels will vary depending on the rules.
+ Divisions - specifies the number of fixtures to place in each division (when set to Each) or a total number of
divisions in which to place all of the fixtures (when set to Total.). The number of divisions can be set from 1 to
2000. For example, you could have two (2) divisions: one for ODD channels and one for EVEN channels.
+ Order - the sequential ordering of channels in the group. Options for channel order include Selection (default),
Channel Number, X Position, Y Position, X/Y Position, or Rule Group.
Tab
Arrangement Settings Divisions