Analog outputs, Alarm contact, Communication interface – Basler Electric BE1-11t User Manual
Page 532: Temperature, Standards
520
9424200995 Rev H
Maximum Lead Length ............... 150 feet (4.25 km) with 22 AWG (0.326 mm
2
) wire
Sensing Current Level ................ 2.5 mA
Isolation ...................................... 35 Vpp
Analog Outputs
The RTD module contains four programmable analog outputs.
Rating ......................................... 4 to 20 mAdc or 0 to 10 Vdc (user-selectable)
Current
Accuracy.....................................
±0.053% of full scale (10 V) at 25°C
Temperature Dependence .........
±0.029% drift per degree Celsius
Voltage
Accuracy.....................................
±0.055% of full scale (20 mA) at 25°C
Temperature Dependence .........
±0.04% drift per degree Celsius
Alarm Contact
Type ........................................... Form C (SPDT)
Rating ......................................... 24/48/125/250 Vdc at:
o
30 A make for 0.2 seconds
o
7 A continuous
o
0.3 Adc Break (L/R = 0.04)
Communication Interface
Ethernet
An RTD module with part number 9444100101 is equipped with both fiber and copper Ethernet
connections. An RTD module with part number 9444100100 is equipped with only a copper Ethernet
connection.
Copper Type (RJ45 Connector)
Version ...................................................................... 10BASE-T/100BASE-TX
Maximum Length (One Network Segment) ............... 328 ft (100 m)
Fiber Optic Type (ST Connector)
Version ...................................................................... 100BASE-FX, multimode
Maximum Length (Half-Duplex) ................................ 1,310 ft (399 m)
Maximum Length (Full-Duplex) ................................. 6,600 ft (2,011 m)
Serial
RS-485 19,200 baud
Temperature
Operating Range ........................ –40
°C to 70°C (–40°F to 158°F)
Storage Range ........................... –40
°C to 70°C (–40°F to 158°F)
Standards
IEC 60068-1:
Environmental Testing Part 1: General and Guidance. Temperature Test
IEC 60068-2-1: Basic Environmental Testing Procedures, Part 2: Tests - Test Ad: Cold (Type Test)
IEC 60068-2-2: Basic Environmental Testing Procedures, Part 2: Tests - Test Bd: Dry Heat (Type Test)
IEC 60068-2-28: Environmental Testing Part 2: Testing-Guidance for Damp Heat Tests
IEC 60068-2-38: Composite Temperature/Humidity Cyclic Test
IEC 60255-4:
Single Input Energizing Quantity Measuring Relays with Dependent Specified Time
RTD Module
BE1-11t