Freescale Semiconductor DSP56366 - Manual (Page 121)

HDI08 – External Host Programmer’s Model
DSP56366 24-Bit Digital Signal Processor User Manual, Rev. 4
Freescale Semiconductor 6-27
6.6.7 Host Side Registers After Reset
Table 6-15 shows the result of the four kinds of reset on bits in each of the HDI08 registers seen by the
host processor. The hardware reset (HW) is caused by asserting the RESET signal. The software reset
(SW) is caused by executing the RESET instruction. The individual reset (IR) is caused by clearing the
HEN bit in the HPCR register. The stop reset (ST) is caused by executing the STOP instruction.
6.6.8 General Purpose INPUT/OUTPUT (GPIO)
When configured as general-purpose I/O, the HDI08 is viewed by the DSP core as memory-mapped
registers (see
Section 6.5, "HDI08 – DSP-Side Programmer’s Model" ) that control up to 16 I/O pins. The
software and hardware resets clear all DSP-side control registers and configure the HDI08 as GPIO with
all 16 signals disconnected. External circuitry connected to the HDI08 may need external
pull-up/pull-down resistors until the signals are configured for operation. The registers cleared are the
HPCR, HDDR and HDR. Selection between GPIO and HDI08 is made by clearing HPCR bits 6 through
1 for GPIO or setting these bits for HDI08 functionality. If the HDI08 is in GPIO mode, the HDDR
configures each corresponding signal in the HDR as an input signal if the HDDR bit is cleared or as an
output signal if the HDDR bit is set (see
Section 6.5.7, "Data direction register (HDDR)" and
Section 6.5.8, "Host Data Register (HDR)" ).
Table 6-15 Host Side Registers After Reset
Register
Name
Register
Data
Reset Type
HW
Reset
SW
Reset
IR
Reset
ST
Reset
ICR All Bits 0 0 — —
CVR HC 0 0 0 0
HV[6:0] $32 $32 — —
ISR HREQ 0 0 1 if TREQ is set;
0 otherwise
1 if TREQ is set;
0 otherwise
HF3-HF2 0 0 — —
TRDY 1 1 1 1
TXDE 1 1 1 1
RXDF 0 0 0 0
IVR IV[7:0] $0F $0F — —
RX RXH:RXM:RXL empty empty empty empty
TX TXH:TXM:TXL empty empty empty empty
Note: A long dash (—) denotes that the register value is not affected by the specified reset.