7 serial host interface, 1 introduction, Serial host interface -1 – Freescale Semiconductor DSP56366 User Manual
Page 125: Introduction -1, Section 7, "serial host interface, 7serial host interface
DSP56366 24-Bit Digital Signal Processor User Manual, Rev. 4
Freescale Semiconductor
7-1
7
Serial Host Interface
7.1
Introduction
The Serial Host Interface (SHI) is a serial I/O interface that provides a path for communication and
program/coefficient data transfers between the DSP and an external host processor. The SHI can also
communicate with other serial peripheral devices. The SHI supports two well-known and widely used
synchronous serial buses: the Freescale Serial Peripheral Interface (SPI) bus and the Philips
Inter-Integrated-Circuit Control (I
2
C) bus. The SHI supports either bus protocol as either a slave or a
single-master device. To minimize DSP overhead, the SHI supports 8-bit, 16-bit and 24-bit data transfers.
The SHI has a 1 or 10-word receive FIFO that permits receiving up to 30 bytes before generating a receive
interrupt, reducing the overhead for data reception.
When configured in the SPI mode, the SHI can perform the following functions:
•
Identify its slave selection (in slave mode)
•
Simultaneously transmit (shift out) and receive (shift in) serial data
•
Directly operate with 8-, 16- and 24-bit words
•
Generate vectored interrupts separately for receive and transmit events and update status bits
•
Generate a separate vectored interrupt for a receive exception
•
Generate a separate vectored interrupt for a bus-error exception
•
Generate the serial clock signal (in master mode)
•
Trigger DMA interrupts to service the transmit and receive events
When configured in the I
2
C mode, the SHI can perform the following functions:
•
Detect/generate start and stop events
•
Identify its slave (ID) address (in slave mode)
•
Identify the transfer direction (receive/transmit)
•
Transfer data byte-wise according to the SCL clock line
•
Generate ACK signal following a byte receive
•
Inspect ACK signal following a byte transmit
•
Directly operate with 8-, 16- and 24-bit words
•
Generate vectored interrupts separately for receive and transmit events and update status bits
•
Generate a separate vectored interrupt for a receive exception
•
Generate a separate vectored interrupt for a bus error exception
•
Generate the clock signal (in master mode)
•
Trigger DMA interrupts to service the transmit and receive events