Freescale Semiconductor DSP56366 - Manual (Page 48)

Serial Host Interface
DSP56366 24-Bit Digital Signal Processor User Manual, Rev. 4
2-14 Freescale Semiconductor
SS Input Tri-stated SPI Slave Select — This signal is an active low Schmitt-trigger input when
configured for the SPI mode. When configured for the SPI Slave mode, this
signal is used to enable the SPI slave for transfer. When configured for the SPI
master mode, this signal should be kept deasserted (pulled high). If it is
asserted while configured as SPI master, a bus error condition is flagged. If SS
is deasserted, the SHI ignores SCK clocks and keeps the MISO output signal
in the high-impedance state.
HA2 Input I
2
C Slave Address 2 — This signal uses a Schmitt-trigger input when
configured for the I
2
C mode. When configured for the I
2
C Slave mode, the HA2
signal is used to form the slave device address. HA2 is ignored in the I 2 C master
mode.
This signal is tri-stated during hardware, software, and individual reset. Thus,
there is no need for an external pull-up in this state.
This input is 5 V tolerant.
HREQ Input or Output Tri-stated Host Request — This signal is an active low Schmitt-trigger input when
configured for the master mode but an active low output when configured for the
slave mode.
When configured for the slave mode, HREQ is asserted to indicate that the SHI
is ready for the next data word transfer and deasserted at the first clock pulse
of the new data word transfer. When configured for the master mode, HREQ is
an input. When asserted by the external slave device, it will trigger the start of
the data word transfer by the master. After finishing the data word transfer, the
master will await the next assertion of HREQ to proceed to the next transfer.
This signal is tri-stated during hardware, software, personal reset, or when the
HREQ1–HREQ0 bits in the HCSR are cleared. There is no need for external
pull-up in this state.
This input is 5 V tolerant.
Table 2-10 Serial Host Interface Signals (continued)
Signal
Name
Signal Type
State during
Reset
Signal Description