Manual conventions – Freescale Semiconductor DSP56366 User Manual
Page 22
DSP56366 24-Bit Digital Signal Processor User Manual, Rev. 4
ii
Freescale Semiconductor
SECTION 6— HOST INTERFACE (HDI08)
•
Describes the HDI08 parallel host interface.
SECTION 7—SERIAL HOST INTERFACE (SHI)
•
Describes the serial input/output interface providing a path for communication and
program/coefficient data transfers between the DSP and an external host processor. The SHI can
also communicate with other serial peripheral devices.
SECTION 8—ENHANCED SERIAL AUDIO INTERFACE (ESAI)
•
Describes one of the full-duplex serial port for serial communication with a variety of serial
devices.
SECTION 9—ENHANCED SERIAL AUDIO INTERFACE 1 (ESAI_1)
•
Describes the second full-duplex serial port for serial communication with a variety of serial
devices.
SECTION 10—DIGITAL AUDIO TRANSMITTER (DAX)
•
Describes the full-duplex serial port for serial communication with a variety of serial devices.
SECTION 11—TRIPLE TIMER MODULE (TEC)
APPENDIX A—BOOTSTRAP PROGRAM
•
Lists the bootstrap code used for the DSP56366.
APPENDIX B—EQUATES
•
Lists equates for the DSP56366.
APPENDIX C—JTAG/BSDL LISTING
•
Provides the BSDL listing for the DSP56366.
APPENDIX D—PROGRAMMING REFERENCE
•
Lists peripheral addresses, interrupt addresses, and interrupt priorities for the DSP56366. Contains
programming sheets listing the contents of the major DSP56366 registers for programmer
reference.
Manual Conventions
The following conventions are used in this manual:
•
Bits within registers are always listed from most significant bit (MSB) to least significant bit
(LSB).
•
When several related bits are discussed, they are referenced as AA[n:m], where n>m. For purposes
of description, the bits are presented as if they are contiguous within a register. However, this is not
always the case. Refer to the programming model diagrams or to the programmer’s sheets to see
the exact location of bits within a register.
•
When a bit is described as “set”, its value is 1. When a bit is described as “cleared”, its value is 0.