Freescale Semiconductor ColdFire MCF52210 - Manual (Page 449)

Analog-to-Digital Converter (ADC)
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor 26-13
26.4.7 Limit Status Register (ADLSTAT)
The ADC limit status (ADLSTAT) register latches in the result of the comparison between the result of the
sample in the ADRSLTn register and the respective limit register, ADHLMTn or ADLLMTn.
For example, if the result for ADRSLT0 is greater than the value programmed into ADHLMT0, then the
the HLS0 bit is set. An interrupt is generated if CTRL1[HLMTIE] is set.
These bits are sticky—they are not cleared automatically by subsequent conversions. A bit may only be
cleared by writing a 1 to it.
8
HLMTI
High Limit Interrupt bit. If any high limit register (ADHLMTn) is enabled by having a value other than 0x7FF8,
high limit checking is enabled. This bit is set at the completion of an individual conversion which may or may
not be the end of a scan. It is cleared by writing 1 to all active ADLSTAT[HLS] bits.
0 No high limit interrupt request
1 High limit exceeded, IRQ pending if CTRL1[HLMTIE] is set
7–0
RDYn
Ready Sample bits. These bits indicate samples 7-0 are ready to be read. The RDYn bits are set as the
individual channel conversions are completed and stored in a ADRSLTn register. These bits are cleared after
a read from the corresponding ADC results (ADRSLTn) register. If polling the RDYn bits to determine if a
particular sample is executed, care should be taken not to start a new scan until all enabled samples are
completed.
0 Sample not ready or has been read
1 Sample ready to be read
Note: RDYn bits can be cleared when the debugger reads the corresponding results register during a debug
session.
IPSBAR
Offset: 0x19_000E (ADLSTAT)
Access: read/write
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
HLS7 HLS6 HLS5 HLS4 HLS3 HLS2 HLS1 HLS0 LLS7 LLS6 LLS5 LLS4 LLS3 LLS2 LLS1 LLS0
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Figure 26-10. Limit Status Register (ADLSTAT)
Table 26-12. ADLSTAT Field Descriptions
Field Description
15–8
HLSn
High Limit Status bits. These bits hold the result of a comparison between the sample (stored in ADRSLTn)
and the high-limit value (stored in ADHLMTn).
0 Sample n is less than or equal to the associated high-limit value
1 Sample n is greater than the associated high-limit value
Note: These bits are sticky, and can only be cleared by writing a 1 to them.
7–0
LLSn
Low Limit Status bits. These bits hold the result of a comparison between the sample (stored in ADRSLTn)
and the low-limit value (stored in ADLLMTn).
0 Sample n is greater than or equal to the associated low-limit value
1 Sample n is less than the associated low-limit value
Note: These bits are sticky, and can only be cleared by writing a 1 to them.
Table 26-11. ADSTAT Field Descriptions (continued)
Field Description