Freescale Semiconductor ColdFire MCF52210 - Manual (Page 512)

Debug Module
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
28-16 Freescale Semiconductor
contents of the breakpoint registers are compared with the processor’s program counter register when TDR
is configured appropriately.
The PC breakpoint registers are accessible in supervisor mode using the WDEBUG instruction and
through the BDM port using the
WDMREG command using values shown in Section 28.5.3.3, “Command
Set Descriptions” .
Figure 28-9 shows PBMR. PBMR is accessible in supervisor mode using the WDEBUG instruction and
via the BDM port using the WDMREG command. PBMR only masks PBR0.
DRc[4:0]: 0x08 (PBR0) Access: Supervisor write-only
BDM write-only
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
W Address
Reset – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
Figure 28-7. PC Breakpoint Register (PBR0)
Table 28-10. PBR0 Field Descriptions
Field Description
31–0
Address
PC Breakpoint Address. The address to be compared with the PC as a breakpoint trigger.
Note: PBR0[0] should always be loaded with a 0.
DRc[4:0]: 0x18 (PBR1)
0x1A (PBR2)
0x1B (PBR3)
Access: Supervisor write-only
BDM write-only
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
W Address V
Reset – – – – – – – – – – – – – – – – – – – – – – – – – – – – – 0 0 0
Figure 28-8. PC Breakpoint Register n (PBRn)
Table 28-11. PBRn Field Descriptions
Field Description
31–1
Address
PC Breakpoint Address. The 31-bit address to be compared with the PC as a breakpoint trigger.
0
V
Valid Bit. This bit must be set for the PC breakpoint to occur at the address specified in the Address field.
0 PBR is disabled.
1 PBR is enabled.