Freescale Semiconductor ColdFire MCF52210 - Manual (Page 334)

Programmable Interrupt Timers (PIT0–PIT1)
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
20-4 Freescale Semiconductor
20.2.2 PIT Modulus Register (PMRn)
The 16-bit read/write PMRn contains the timer modulus value loaded into the PIT counter when the count
reaches 0x0000 and the PCSRn[RLD] bit is set.
When the PCSRn[OVW] bit is set, PMRn is transparent, and the value written to PMRn is immediately
loaded into the PIT counter. The prescaler counter is reset (0xFFFF) anytime a new value is loaded into
the PIT counter and also during reset. Reading the PMRn returns the value written in the modulus latch.
Reset initializes PMRn to 0xFFFF.
5
DBG
Debug mode bit. Controls the function of PIT in halted/debug mode. Reset clears DBG. During debug mode, register
read and write accesses function normally. When debug mode is exited, timer operation continues from the state it
was in before entering debug mode, but any updates made in debug mode remain.
0 PIT function not affected in debug mode
1 PIT function stopped in debug mode
Note: Changing the DBG bit from 1 to 0 during debug mode starts the PIT timer. Likewise, changing the DBG bit
from 0 to 1 during debug mode stops the PIT timer.
4
OVW
Overwrite. Enables writing to PMRn to immediately overwrite the value in the PIT counter.
0 Value in PMRn replaces value in PIT counter when count reaches 0x0000.
1 Writing PMRn immediately replaces value in PIT counter.
3
PIE
PIT interrupt enable. This read/write bit enables PIF flag to generate interrupt requests.
0 PIF interrupt requests disabled
1 PIF interrupt requests enabled
2
PIF
PIT interrupt flag. This read/write bit is set when PIT counter reaches 0x0000. Clear PIF by writing a 1 to it or by
writing to PMR. Writing 0 has no effect. Reset clears PIF.
0 PIT count has not reached 0x0000.
1 PIT count has reached 0x0000.
1
RLD
Reload bit. The read/write reload bit enables loading the value of PMRn into PIT counter when the count reaches
0x0000.
0 Counter rolls over to 0xFFFF on count of 0x0000
1 Counter reloaded from PMRn on count of 0x0000
0
EN
PIT enable bit. Enables PIT operation. When PIT is disabled, counter and prescaler are held in a stopped state. This
bit is read anytime, write anytime.
0 PIT disabled
1 PIT enabled
IPSBAR
Offset:
0x15_0002 (PMR0)
0x16_0002 (PMR1) Access: Supervisor
read/write
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
PM
W
Reset 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Figure 20-3. PIT Modulus Register (PMRn)
Table 20-3. PCSRn Field Descriptions (continued)
Field Description