Freescale Semiconductor ColdFire MCF52210 - Manual (Page 267)

Universal Serial Bus, OTG Capable Controller
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor 15-39
15.7.3 Power
The USB-FS core is a fully synchronous static design. The power used by the design is dependant on the
application usage of the core. Applications that transfer more data or cause a greater number of packets to
be sent consumes a greater amount of power.
Because the design is synchronous and static, reducing the transitions on the clock net may conserve
power. This may be done in the following ways.
The first is to reduce the clock frequency to the USB module. The clock frequency may not be reduced
below the minimum recommended operating frequency of the USB module without first disabling the
USB operation and disconnecting (via software disconnect) the USB module from the USB bus.
Alternately, the clock may be shut off to the core to conserve power. Again, this may only be done after
the USB operations on the bus have been disabled and the device has been disconnected from the USB.
B_SRP_INIT If ID\ Interrupt or SRP Done (SRP must be done in less than 100
msecs.) Go to B_IDLE
B_PERIPHERAL If HNP enabled and the bus is suspended and B wants the bus,
the B device can become the host. Go to B_WAIT_ACON
Turn off DP_HIGH
B_WAIT_ACON If A connects, that is, an attach interrupt is received Go to B_HOST
Turn on Host Mode
If ID\ Interrupt or B_SESS_VLD/ Interrupt
If the cable changes or if VBUS goes away, the host doesn’t
support us.
Go to B_IDLE Go to B_IDLE
If 3.125 ms expires or if a Resume occurs Go to B_PERIPHERAL
B_HOST If ID\ Interrupt or B_SESS_VLD\ Interrupt
If the cable changes or if VBUS goes away, the host doesn’t
support us. Go to B_IDLE
If B application is done or A disconnects Go to B_PERIPHERAL
Table 15-39. State Descriptions for Figure 15-34 (continued)
State Action Response