16 pulse accumulator flag register (gptpaflg), 16pulse accumulator flag register (gptpaflg) -14 – Freescale Semiconductor ColdFire MCF52210 User Manual
Page 352
General Purpose Timer Module (GPT)
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
21-14
Freescale Semiconductor
21.6.16 Pulse Accumulator Flag Register (GPTPAFLG)
Table 21-18. GPTPACTL Field Descriptions
Field
Description
7
Reserved, should be cleared.
6
PAE
Enables the pulse accumulator.
1 Pulse accumulator enabled
0 Pulse accumulator disabled
Note: The pulse accumulator can operate in event mode even when the GPT enable bit, GPTEN, is clear.
5
PAMOD
Pulse accumulator mode. Selects event counter mode or gated time accumulation mode.
1 Gated time accumulation mode
0 Event counter mode
4
PEDGE
Pulse accumulator edge. Selects falling or rising edges on the PAI pin to increment the counter.
In event counter mode (PAMOD = 0):
1 Rising PAI edge increments counter
0 Falling PAI edge increments counter
In gated time accumulation mode (PAMOD = 1):
1 Low PAI input enables divide-by-64 clock to pulse accumulator and trailing rising edge on PAI sets PAIF flag.
0 High PAI input enables divide-by-64 clock to pulse accumulator and trailing falling edge on PAI sets PAIF flag.
Note: The timer prescaler generates the divide-by-64 clock. If the timer is not active, there is no divide-by-64 clock.
To operate in gated time accumulation mode:
1. Apply logic 0 to RSTI pin.
2. Initialize registers for pulse accumulator mode test.
3. Apply appropriate level to PAI pin.
4. Enable GPT.
3–2
CLK
Select the GPT counter input clock. Changing the CLK bits causes an immediate change in the GPT counter clock
input.
00 GPT prescaler clock (When PAE = 0, the GPT prescaler clock is always the GPT counter clock.)
01 PACLK
10 PACLK/256
11 PACLK/65536
1
PAOVI
Pulse accumulator overflow interrupt enable. Enables the PAOVF flag to generate interrupt requests.
1 PAOVF interrupt requests enabled
0 PAOVF interrupt requests disabled
0
PAI
Pulse accumulator input interrupt enable. Enables the PAIF flag to generate interrupt requests.
1 PAIF interrupt requests enabled
0 PAIF interrupt requests disabled
IPSBAR
Offset: 0x1A_0019 (GPTPAFLG)
Access: Supervisor read/write
7
6
5
4
3
2
1
0
R
0
0
0
0
0
0
PAOVF
PAIF
W
Reset:
0
0
0
0
0
0
0
0
Figure 21-18. Pulse Accumulator Flag Register (GPTPAFLG)