Yokogawa FieldMate - Manual (Page 21)

<B Packaging and Installation>
B-7
IM 01R01A01-01E 9th Edition : May 31, 2013-00
7. Select the Yokogawa DTM, or select whether to install other manufacturers’ DD/DTM.
B010308E.ai
The following dialog box appears after you enter the license number and other
information in FieldMate Installer.
This is selected by default. When this is selected,
all the Yokogawa device DTM libraries, assigned
files, Yokogawa device DD, Device Viewer
definition file, Yokogawa Built-in DTM, and the
following items* will be installed.
(*): HART device vendor name/model name file, FF-H1 device vendor name/
model name file, BRAIN device model name file, and ISA100 device vender
name/model name
When this is selected, a Yokogawa device DTM
Installer window for the protocol checked in the
check box appears for installation. This window
enables you to select whether to install or not for
each device (see Part J-2). The following items*
will also be installed.
When this is selected, only the following items* will
be installed.
When this is checked, the Device File Installer
window will be called up after the above Yokogawa
device DTM libraries and the following items* are
installed (see Part J-2). This is unchecked by
default.
Figure B-1-8
8. Select the drive for installation. Default is C drive.
B010309E.ai
Figure B-1-9