Yokogawa FieldMate - Manual (Page 211)

<F Advance>
F-92
IM 01R01A01-01E 9th Edition : May 31, 2013-00
F050230E.ai
Overwrite the
existing Database
device to create a
new device.
Displays a list of
Database devices to be
overwritten. Select the
device DTM data.
Figure F-5-38 Assigning Existing Device Maintenance Information
 Deleting, Importing, and Exporting Device Maintenance Information
The device maintenance information can be deleted, imported, and exported in Device Navigator.
Also, these operations cannot be performed in DTM Works.
 Loading DTM Data in Device Maintenance Info (FDT Project ← Device
Maintenance Info)
You can also select the device DTM registered to the database and load it using Load from
Database.
 Saving and Loading DTM Data in Device Maintenance Info to and from File
You can select the device DTM and output the DTM data to a file using Save to File. You can also
load that file by selecting the device DTM and using Load from File.
These operations can also be performed although the device DTM is not registered to Device
Maintenance Info.
F-5-2-3 Relation between FDT Project and .NET Framework*
* .NET Framework is environment for Windows application software.
According to the specifications defined by the FDT Group, DTM and DTM Works (an application
program) are compatible as follows.
Table F-5-9 Compatibility between Revisions of FieldMate and .NET Framework
DTM Works
FieldMate R2.02 to R2.05 .NET Framework 2.0 or later
R2.01 or earlier .NET Framework 1.1
R2.06 or later .NET Framework 4.0
Based on the relation above, you must follow the procedure below when creating an FDT project.
 Creating a New FDT Project
Designate a version of .NET Framework to use for creating a new project.
This designation applies to all settings of FieldMate.
For details of the operation, see G-2 “Options.”