Yokogawa FieldMate - Manual (Page 223)

<F Advance>
F-104
IM 01R01A01-01E 9th Edition : May 31, 2013-00
 Select the Database Device in Device Navigator and Start up DTM Works by
Selecting Action → Open FDT Project.
1. A window to select the FDT project to which the relevant device belongs appears.
2. Based on the FDT project that was selected by the user, start up DTM Works in the UDC
mode.
3. DTM Works displays a window to select the DTM data. (*1)
4. DTM Works loads the FDT project and displays the Offline window in the disconnected state
in the foreground.
* 1: The selection window appears only when the DTM data is stored in the device maintenance information of the relevant device. If
there is no DTM data, the selection window does not appear and the DTM data is not set. The process goes to step (4).
The subsequent use of Connect allows for transition to the state of being connected to the connected device.
 Start up DTM Works using New FDT Project in Segment Viewer in UDC Mode
1. Starts up DTM Works in the UDC mode.
2. DTM Works starts in the state in which DTM catalog only is displayed.
 Start up DTM Works using Open FDT Project in Segment Viewer in UDC Mode
1. Starts up DTM Works in the UDC mode.
2. DTM Works starts in the state in which the FDT project selected by the user is loaded.