Yokogawa FieldMate - Manual (Page 346)

<Appendix C Device Replacement Tool>
App.-25
IM 01R01A01-01E 9th Edition : May 31, 2013-00
5. Operation
 5-1 Startup
Start → All programs → YOKOGAWA FieldMate → Tools → Device Replacement Tool.
This tool does not start if FieldMate is already running.
If the following message appears, exit FieldMate and then start this tool.
App.C3E.ai
Figure App.-C-3 Error Message when FieldMate is Already Running
(Note) This tool allows only one device to be connected at one time. The original and replacing devices cannot be connected
simultaneously.
 5-2 Step 1
Upload the parameters of the original device and saving them in a file
 Step 1-1 Select a mode
Select “Device -> File”
App.C4E.ai
Figure App.-C-4 Mode Selection Display