Yokogawa FieldMate - Manual (Page 234)

<G FieldMate Setup>
G-9
IM 01R01A01-01E 9th Edition : May 31, 2013-00
G040103E.ai
Figure G-4-3 Message Appears when FieldMate is already Running
 Setting
Select an FOUNDATION fieldbus H1 communication interface after selecting “Built-in
Connection” tab.
G040104E.ai
Figure G-4-4 Selecting a Communication Interface
Basically, FOUNDATION fieldbus H1 interface is automatically selected. The followings show the
installation case.
1. When FFusb from Softing is newly installed, Softing FFusb is selected.
2. When FBUS from National Instruments is newly installed, NI-FBUS is selected.
Even after installing either interface software on the other one was already installed, former
selection remains unchanged until user select communication interface manually, either Softing
FFusb or NI-FBUS in the window.
Note : FFusb driver cannot be installed before FieldMate is installed.