Yokogawa FieldMate - Manual (Page 292)

<I ISA100 device configuration>
I-38
IM 01R01A01-01E 9th Edition : May 31, 2013-00
I-6-2 Offline Start
To start up DTM, select a relevant device in Segment Viewer, and start up its DTM from the
Action menu or right-click the menu.
 Selecting the communication path
When DTM is started from Device Navigator, DTM offline window is displayed. Then connect and
change to DTM online window, then communication route will be selected.
I060201E.ai
Figure I-6-1 Setting the Communication Path Check in the Option Dialog
1. Select the communication route through which DTM is connected after an ISA100 device is
selected in Device Navigator and its DTM is started up.
The default is infrared.
2. Select the communication route through which DTM is connected after a HART device is
selected in Device Navigator and its DTM is started up.
Only device maintenance information registered via HART adaptor can be effective.
The default is “Gateway”.
If this setting differs from the communication route in the device maintenance information,
an error will occur on connection.